ISIS Dev Kit user manual
Issue C
24
ISIS-HDA board
The following diagram shows the location of the connectors on the ISIS-HDA board.
Top view
Connectors
There are four connectors on the ISIS-HDA board; the use of each one is explained
below.
J1 – LINE IN/SURR
Socket
: 3.5mm stereo jack.
Mating plug
: 3.5mm stereo plug.
Pin
Signal name - 2.0 mode
Signal name - 5.1 mode
Tip
Line in left
Rear surround left
Ring
Line in right
Rear surround right
Sleeve Ground
Ground
J2 – MIC IN/CLFE
Socket
: 3.5mm stereo jack.
Mating plug
: 3.5mm stereo plug.
Pin
Signal name - 2.0 mode
Signal name - 5.1 mode
Tip Microphone
1
Surround
centre
Ring
Microphone 2
Low frequency effects
Sleeve Ground
Ground