49
601-000147 Rev. Y
Arch. 5105
25/02/2016
Do not remove power supply modules with the EK-PSI/1
unfixed
APPENDIX
F
EK-PWS/A,
EK-PWS/C
E
EK-PWS/D
POWER SUPPLY INTERFACE
(
EK-PSI/1
).
The EK-PSI/1 is the power supply interface of the EK-MFR/2 system. This unit allows the electrical
and mechanical connections between the power supply unit (EK-PWS/A, EK-PWS/C and EK-
PWS/D) and the EK-MFR/2.
At the 15 contacts connector are connected the relays and the RS-232 interfaces plus +12V supply
for low power pourpose.
On the panel is also located the RJ 45 connector that allows the Ethernet connection (10/100 Base-
T).
On the same board are present all the components that allow for RFI, EMC and ESD protection of
the overwritten interfaces.
Summary of Contents for EK-MFR/2
Page 1: ...1 601 000147 Rev Y Arch 5105 25 02 2016 User Manual System ALL4DIGIT EK MFR 2 ...
Page 9: ...9 601 000147 Rev Y Arch 5105 25 02 2016 1 1 EK MFR 2 BLOCK SCHEME ...
Page 18: ...18 EK MFR 2 25 02 2016 Arch 5105 601 000147 MN Rev Y Tabella 5 1 Indoor version Set up Table ...
Page 66: ...66 EK MFR 2 25 02 2016 Arch 5105 601 000147 MN Rev Y ...
