8097#
)XQFWLRQ
#
%ORFNV
953#
9HFWRU
#
'ULYH
#0#
+$
7968;7
%/2&.
#
',$*5$0
Destination Address
Max.
Scale
Offset
Min
Scaled Input
X
Modulu
Anin
Figure 5.28 Analogue I/P
$1,1
#4#+
&
6,/#
$1,1
#6#+
)
5,/#
$1,1
#7#++
)
6,#
$1'
#
$1,1
#8#+
)
7,
CALIBRATION
Analogue input scaling ratio.
OFFSET
maximum value of scaled analogue input.
MAX. VALUE
maximum value of scaled analogue input.
MIN VALUE
Minimum value of scaled analogue input.
DESTINATION TAG
Destination N° of scaled analogue input value.
SCALED INPUT
Diagnostic (Block Diagram %)
ANIN
Diagnostic (Terminal Volts)
$1,1
#5#+
&
7,
Analogue Input 2 (terminal A3) is not re-configurable. The calibration for this channel is found in
SETUP
PARAMETERS::SPEED LOOP::SETPOINTS::RATIO 2 (A3).
Analogue input 2 is a direct input into the speed loop / current loop and it is scanned synchronously with the current
loop (typically every 1.1.mSecs) rather than every micro cycle time. Therefore it should be used for any signal
whose response is critical e.g. a trim input from microloc, cut to length applications etc.
$/2*8(
#
2873876
00,
#
(175,(6
f.......ANALOG OUTPUTS
f.........ANOUT 1 (C5)
f...........% TO GET 10V [272] = 100.00 %
f...........OFFSET [332] = 0.00 %
f...........HARDWARE OFFSET [676] = 0.00 %
f...........CALIBRATION [330] = 100.00 %
f...........MODULUS [335] = FALSE
f...........ANOUT 1 [354] = 0.00 %
f...........SOURCE TAG [273] = 7
f...........ANOUT 1 (C5) [34] = 0.000 VOLTS
f.........ANOUT 2 (F5)
f...........% TO GET 10V [275] = 150.00 %
f...........OFFSET [333] = 0.00 %
f...........HARDWARE OFFSET [677] = 0.00 %
f...........CALIBRATION [331] = 100.00 %
f...........MODULUS [336] = FALSE
f...........ANOUT 2 [355] = 0.00 %
f...........SOURCE TAG [276] = 9
f...........ANOUT 2 (F5) [35] = 0.000 VOLTS
This manual was downloaded on www.sdsdrives.com
+44 (0)117 938 1800 - info@sdsdrives.com