3
●
IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CHARGER
1. Before using charger, read all instructions and cautionary markings on charger.
2. This charger is not intended for any uses other than charging rechargeable batteries. Any other uses may result in risk
of fire, electric shock or electrocution.
3. To reduce risk of damage to electric plug and cord, disconnect from mains socket by pulling the plug rather than the
cord.
4. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
5. Do not place any object on top of charger or on a surface that might block the ventilation slots and result in excessive
internal heat. Place the charger in position away from any heat source.
6. Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way.
7. Do not disassemble charger. Take it to authorized service center when service or repair is required. Incorrect
reassemble may result in a risk of electric shock, electrocution or fire.
8. To reduce risk of electric shock, unplug charger from outlet before attempting any cleaning. Removing the battery pack
will not reduce this risk.
9. DO NOT store or use the tool in locations where the temperature may reach or exceed 105°F (such as outside sheds or
metal buildings in summer).
10. The charger is designed to operate on standard household electrical power . Do not attempt to use it on any other
voltage!
READ ALL INSTRUCTIONS CAREFULLY AND KEEP IN A SAFE PLACE FOR FUTURE REFERENCE
.
1. Do not incinerate the battery even if it is severely damaged or is completely worn out. The battery can explode in a fire.
2. A small leakage of liquid from the battery cells may occur under extreme usage or temperature conditions. Do not use
the tool any more.
3. Do not disassemble burn or short-circuit batteries.
4. Charge the battery only with the chargers supplied with the product.
5.
NOTE: The battery in your tool is the lithium-ion type, with no self-discharge or memory effect.
●
ASSEMBLY
Fitting/removing the wheels assembly
WARNING: Do not turn on the switch when you fit or remove the wheels assembly. This can cause a serious
injury.
1
,
Fitting/removing the telescopic swivel handle
Fitting the wheels assembly (1):
Push the wheels assembly (1) forward into the
grass shear align the slot until both catches click
into suitable place.
Removing the wheels assembly (1):
Pull the wheels assembly (1) backwards and
remove.
fit
remove
1