Installation and operating instructions no. 49530/49536 page 2 from 2
status 10.2010
Operation:
Fasten the pedometer to the belt at the side.
The number of steps is transmitted to the pedometer by the movement of hips.
Pedometer
Press the mode button until the step symbol appears in the display. The step counter starts to count as
soon as the first step is taken. Display after 5 steps. Press the reset button to reset the pedometer, the
display is reset to 0 steps.
Number of steps taken
Press the mode button until the km symbol appears in the display. Press the set button now to set the
stride length. The display jumps to the cm marking and starts to flash. Press the reset button now until
the desired value appears in the display. The value is saved by pressing the mode button again or by
waiting for 3 seconds.
The stride length can be set in 2 cm intervals between 30 – 150 cm.
The amount of steps take starts to record with the first step.
Press the mode button until the number of steps is shown (the step symbol appears in the display) to set
the number of steps taken back to 0. Press the reset button now and the value moves to 0 in the display.
By pressing the “R” and “M” button for 5 second until the LCD screen flash once, the unit will be change
from km to miles or from miles to km
Calorie consumption
Press the mode button until the Kcal symbol appears in the display. Press the set button now to enter
your bodyweight. The display jumps to Kg and starts to flash. Press the reset button now until the
desired value appears in the display. The value is saved by pressing the mode button again or by waiting
for 3 seconds.
The body weight can be set in 1kg intervals between 30 – 135 kg.
The used calories start recording with the first step.
Press the mode button until the number of steps is shown (the step symbol appears in the display) to set
the number of calories used back to 0. Press the reset button now and the value moves to 0 in the
display.
Automatic switch-off
The pedometer switches off automatically if there has been no movement after 1 minute. The existing
values remain stored. The pedometer switches on again as soon as you start to walk again.
LED light
The LED light is switched on by pressing the sliding switch on the lower side to the LIGHT position.
Switch-off position OFF.
Warning signal
The permanent warning signal is switched on by pressing the sliding switch on the lower side to the
SIREN position. Switch-off position OFF.
Fault diagnosis:
Faulty step display
Set the pedometer in accordance with the operating instructions. Check all the settings. Make sure that
your style of walking is correct.
Dark LCD display
Weak battery, replace.
Environmental temperature is too low. The display on the unit improves with rising temperatures.
Black LCD display
The pedometer has been operated in the direct sunlight over a longer period of time or under
environmental conditions which were too hot. The display will become normal when temperatures drop,
or when in the shade.
LCD Display
Mode button
Set button
Battery housing
LED light
Reset button
Belt clip
Function switch
Heitronic
®
H. Vollmer GmbH
Allmendring 29
D-75203 Königsbach-Stein
