V 2100 /
BT168
BATTERY TRANSPORT CASE EN
Warning:
Please read this instruction manual carefully before using the instrument and keep it for future use.
A.
HOW TO USE IT
Capacity :
6 button cell batteries LR44
6 button cell batteries CR2025/CR2032
12 batteries « AA »
/ 12 batteries « AAA » /4 batteries « 9V »
/ 4 batteries « D »
4 batteries « C »
To test a battery, remove the tester from the transport case.
Always pay attention to respect the polarity and to always see a good quality of contact.
Easy-to-read, colour-coded meter indicates power level
For 1.5v and 9v batteries, read off upper scale.
For 1.5v miniature cells, read off ‘button battery’ scale
If needle does not move, check that battery is touching both contacts before assuming that it is completely dead.
The battery Tester may be used to test the following sizes:
1.5v: AAA, HP16, MN2400, R03
AA, HP7, MN1500, UM3
C, HP11, MN1400, SP11, LR14, UM2
D, HP2, MN1300, SP2, R20, UM1
9v: PP3, MN1604, 6F22, 006P
Don’t forget
The Battery Tester is activated by the battery being checked. Keep test times as short as possible, to avoid unnecessary
battery drain.
B.
CARE AND MAINTENANCE
Keep the battery organizer dry, wipe immediately if it gets wet.
Store and use in normal temperature environments only. Don’t drop battery organizer.
Keep away from dust and dirt. Insert the correct battery size into the appropriate storage slot.
The European directive 2012/19/EC about electronic and electric waste, requires that you can’t throw away defective
domestic appliance with common waste. Used device has to be collect separately to optimize the recuperation rate and the
recycling of the materials to reduce the impact on the health and the environment.
