Instruction Manual
2.
Battery cover and desktop stand
3.
Wall mount and Time Setting
Instructions:
1. Place the clock with face of the clock facing upwards and to be parallel with the surface of your desk.
Carefully slide the three markers on the appropriate orbits until the markers are held in place by the
magnets.
2. Tilt the clock up to adjust the time with the time set knob.
3. The clock uses 1 ‘AA’ size alkaline battery and match the polarity as marked on the clock.
Attention:
Remove tapes at the back of the clock applied for shipment purpose.
Warning:
This is not a toy. Contains small parts that may pose a choking hazard. Keep out of reach of children.
It's recommended to shake the balls to loosen the magnet prior to placing the balls on the clock.
If the ball(s) are not rolling smoothly on the surface, remove and replace the balls.
The balls should be rolling on the surface smoothly.
Minute marker
Hour marker
Second marker
1.
Attaching the markers
The inner most orbit is the seconds.
The middle orbit is the hours.
The outer orbit is the minutes.
Time set knob
Hang hole for wall mount
Pull out
Press down
Battery cover
and Desktop stand
Consideration of duty according to the battery law
Old batteries do not belong to domestic waste because they could
cause damages of health and environment. You can return used
batteries free of charge to your dealer and collection points.
As end-user you are committed by law to bring back needed batteries
to distributors and other collecting points!
WT 7350 GALAXY MAGNET CLOCK
Alternate model:
Some models are equipped with the golden sun in the middle of the clock. These models will include a half golden
sphere. Snap the golden sphere onto the ace of the clock.
