MM850592 ed. 01 - Mini MMX II
13
BATTERY INSTALLATION
WARNING
T
O AVOID ELECTRIC SHOCK
,
DISCONNECT THE TEST LEADS FROM ANY SOURCE OF VOLTAGE BEFORE REMOVING THE
BATTERY DOOR
.
1. Disconnect the test leads from the meter.
2. Open the battery door by loosening the screw using a Phillips head screwdriver.
3. Insert the battery into battery holder, observing the correct polarity.
4. Put the battery door back in place. Secure with the two screws.
WARNING
T
O AVOID ELECTRIC SHOCK
,
DO NOT OPERATE THE METER UNTIL THE BATTERY DOOR IS IN PLACE AND FASTENED
SECURELY
.
NOTE:
I
F YOUR METER DOES NOT WORK PROPERLY
,
CHECK THE FUSES AND BATTERY TO MAKE SURE THAT THEY ARE
STILL GOOD AND THAT THEY ARE PROPERLY INSERTED
.
REPLACING THE FUSES
WARNING
T
O AVOID ELECTRIC SHOCK
,
DISCONNECT THE TEST LEADS FROM ANY SOURCE OF VOLTAGE BEFORE REMOVING THE
FUSE DOOR
.
1. Disconnect the test leads from the meter and any item under test.
2. Open the fuse door by loosening the screw on the door using a Phillips head screwdriver.
3. Remove the old fuse from its holder by gently pulling it out.
4. Install the new fuse into the holder.
5. Always use a fuse of the proper size and value (0.5A/1000V fast blow for the 400mA range, 10A/1000V
fast blow for the 10A range).
6. Put the fuse door back in place. Insert the screw and tighten it securely.
WARNING
T
O AVOID ELECTRIC SHOCK
,
DO NOT OPERATE YOUR METER UNTIL THE FUSE DOOR IS IN PLACE AND FASTENED
SECURELY
.
