-10-
2.1.2. Rear Panel
Figure 2-2 Rear Panel
Ports:
Port
Description
RESET
To reset system settings to factory defaults, please follow the steps:
1. Power off the device,
2. Press the reset button and hold,
3. Power on the device,
4. Keep the button pressed about 5 seconds,
5. Release the button,
6. Watch the M1 and M2 LEDs, they will flash 8 times and then M1
flash once per second.
12VDC
Power inlet: DC 12V, 1.2A (minimum)
PRINTER
Printer Port (Optional)
COM
Serial port (connect analog modem or console cable)
2.2 Procedure for Hardware Installation
1. Decide where to place your Wireless Broadband Router:
You can place your Wireless Broadband Router on a desk or other flat surface, or you
can mount it on a wall. For optimal performance, place your Wireless Broadband
Router in the center of your office (or your home) in a location that is away from any
potential source of interference, such as a metal wall or microwave oven.
Summary of Contents for GL2411-AR
