[
20
]
the Connections Panel
Searching for an almost normal LFO?
It's simple. Just feedback the rear EG out into the front EG Gate input. Then with Sustain and Release
to minimum you have a basilar Attack/Decay looping LFO. This configuration cut away the push button (it
doesn't work until you unplug the cable).
•
EG:
required to bypass the VCF/VCA limitation, this rear port is a copy of the EG signal. It follows the main
rule for a doubled signal: it's the same of the first one. So what you see from the front LED is what you get
from the output socket, assuming that obviously in the meantime you actually control the VCF or the VCA
via front panel switch.
So you can have your loop or your triggered ADSR response driving both MCf (aka VCF) and e.g. A filterboard
(
A-Cf CV input
), or both MCf and VCA (via
AM input
), or VCA (
AM in
) and
B filter
(
B-CV input
) and so on.
But you can also obtain something like Master Vertice that lead another Slave Device that can follow a
square LFO (created by the internal EG in looping mode), like an analog sequencer, and now re-use this
"following Vertice's tempo" informations to command the filterboards, another device Tuning factor or
other parameters, the VCA (
AM input
), the
V/oct
, even the GATE of the EG itself. It's sound weird? Yes.
Try to imagine how much deeply can become the audio manipulation on Vertice using these five socket with a
bit, nothing more, of creativity.
If you need to cry this is the moment.
Summary of Contents for Vertice
