Support for Association Groups
ZW47 supports 3 association groups. Group 1 support 1 node ID,Group 2--3 Support maximum of 5 node ID’s
Association group_1:Z-Wave Plus Lifeline
Association group_1 is default to associate with the primary controller (Gateway/Hub/Controller) for ZW47 Status change report,
1. ZW47 will trigger AUTO report function if the Switch status had been changed.
Association group_2:basic set command
send out a related basic set command. On (0xFF) or Off (0x00) to its associated group.
Association group_3:basic set command
send out a related basic set command. On (0xFF) or Off (0x00) to its associated group.
Support for Overload Protection
ZW47 support Overload Protection ,When the ZW47 load exceeds the overload setting value, the overload signal is sent out
Notification Type : Overload 0x08 . Event :Overload detected 0x08
Restoring Factory Defaults
ZW47 is removed from the network and will be restored to the factory setting
All Configuration Parameters values and Association information will be restored to factory default settings and excluded from the network.
Remark : All the setting and data will be permanently deleted.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
When the output of the ZW47 Enpoint2 socket is changed, On (0xFF) or Off (0x00)orOverload, The ZW47 will automatically
When the output of the ZW47 Enpoint1 socket is changed, On (0xFF) or Off (0x00)orOverload, The ZW47 will automatically