Warranty/ Disclaimer
EVACUAID LTD WARRANTS YOUR EVACUAID TO BE FREE FROM
DEFECTS IN WORKMANSHIP AND MATERIALS FOR A PERIOD OF
TWO (2) YEARS FROM THE DATE OF PURCHASE. THE GUARANTEE
APPLIES PROVIDED THAT THE INSTRUCTIONS ARE FOLLOWED.
DEFECTIVE PRODUCTS SHOULD BE RETURNED TO THE PLACE OF
PURCHASE. BATTERIES ARE NOT COVERED BY THIS WARRANTY.
THE MANUFACTURER IS NOT LIABLE FOR PERSONAL OR MATERIAL
DAMAGES OR OTHER DAMAGE DIRECTLY OR INDIRECTLY
CAUSED BY FIRE OR OTHER DISASTERS. ALL GUARANTEES OR
WARRANTIES, EXPRESSED OR IMPLIED, IS STRICTLY LIMITED
TO REPAIRING THE PRODUCT OR RECPLACING DAMAGED
PRODUCT WITH NEW PRODUCT OR EQUIVALENT ITS VALUE.
MANUFACTURER’S LIABILITY SHALL UNDER ANY CONDITIONS
INCLUDING PRODUCT MALFUNCTION BE LIMITED TO PRODUCT
PURCHASING PRICE. EVACUAID EMERGENCY BRACELET SHALL
IN NO EVENT REPLACE REAL ESTATE INSURANCE, INJURY
INSURANCE, DISABILITY INSURANCE, LIFE INSURANCE, OR
OTHER INSURANCE. LIABILITY FOR SUCH INSURANCE IS EVERY
CUSTOMER’S OWN RESPONSIBILITY.
Battery Change
It is recommended to use the SAFT LS 14500 or Tadiran SL760iXtra
Contact your nearest distributor regarding alternative batteries.
In case of battery change the lid must be fixed with a 0.20 to 0.30 Nm
of torque to ensure the tightness factor of IP67.
**
Lithium batteries often have a lower voltage when first used,
because they require a small surge to activate batteries fully. This does
not affect performance, and batteries are kept fresh due to a small
surge every 8 seconds when they are inserted. However, this affects
the battery test when batteries are newly inserted, as voltage testing
may show a low charge even if the batteries are in fact at full capacity.
Therefore, if batteries are newly inserted but not fully refreshed, the
battery check will show a full charge, but will signify low voltage by
giving red blinks every 2s for 2 minutes after testing. The batteries are
refreshed after 2-7 days of being inserted, and battery check will then
function as normal. However, if the inserted batteries are dead or near
dead, this will only be signified 2-7 days after batteries are inserted. If
the batteries were partially charged, the software estimation between
5-100% will be meaningless.
Care and Maintenance
Evacuaid PRO Emergency Bracelet is maintenance free and has no
need for specific maintenance. Note otherwise the following points:
·
In case of strong soiling the device may be rinsed with cold water.
If necessary, use a sponge to wash off.
·
Wipe the bracelet with a cloth.
Technical Specifications
Housing material: Overmoulded polycarbonate, 2K
Ingress protection: IP67
Alarm volume: 90dB (A) within a 3 meter range
Operating time: See included matrix
Dimensions: 83 x 69 x 32 mm [H x W x D]
CE marking and tests: EMC, EN 61000-6-2, EN 61000-6-3
FCC CFR 47 Part 15 : 2008
Disposal of the emergency bracelet
As of August 2005 EU regulations are applied
for disposal of electronic and electrical
appliances, laid down in EU policy 2002/96/EU
and relevant national legislation, which applies
to this appliance.
Evacuaid PRO
Emergency Bracelet Manual - Model 201
www.evacuaid.com
Manufacturer:
Evacuaid AS
Gaustadalleen 21, Oslo Innovation Centre
0349 Oslo
Norge/Norway
Battery life and Service Concept
Remaining %
75 - 100 %
Estimated remaining hours
EM / MEM/ PSAM *
Battery testing
When the unit is deactivated, pressing the alarm button for 6 seconds initiates a battery check.
This gives a software estimation of remaining capacity when batteries are between 100%-5%
capacity. The top signal LEDs will flash according to the table below. Due to the voltage profile
of lithium batteries the estimation is done by software monitoring, so only specified batteries
must be used and fully charged for estimation between 5%-100% to be meaningfull.
If the capacity is 5% and below this will be indicated by 4 red flashes, and a continuous red
flash every 2-8 seconds until batteries are replaced. The check for below 5% is done through
voltage check, and is also performed after every use. When this is indicated, batteries must be
replaced immediately.
Blink sequence
when testing
50 - 75 %
25 - 50 %
10 - 25%
< 10 %
+ continuous red
blinks every 2 - 8
seconds
+ red blinks every 2
s for 2 minutes
> 34 / 15 / 195
> 21 / 9 / 115
>10 / 4 / 50
> 4 / 1,5 / 17
We recommend changing batteries
< 4 / 1,5 / 17
Batteries should be replaced
< 2 / 0,7 / 6
Batteries must be replaced, unit
can cease to function at any time
New batteries not yet refreshed**
* EM = Evacuation Mode MEM = Manual Emergency Mode PSAM = Power Save Alarm Mode
