Main Functions of Push Buttons
Main Activation (red push button) –
Activates a full alarm (audible & visual)
on the device and any other devices on the same frequency that is paired and
in range.
Test Button (red) –
Activates the strobe light and the battery test LED’s on
the device and any other devices on the same frequency that is paired and in
range.
Reset System (black) –
Resets the device back to standby mode and any
other devices on the same frequency that are paired and in range.
On/Off Switch –
Closes the unit down into safe storage mode. (Please
remove batteries for long term storage to avoid leaking cells that may
damage the unit)
Please Note –
After each command allow a minimum of 80 seconds for the
system to reset i.e. If you are silent testing the system via the red button and you
hit the black system reset button allow the system 80 seconds for it to go back into
Standby mode. This also applies to the main Activation button.
Testing the System (Red Button)
This enables the user to visually check that units are in range without activating the
sounders. We recommend that the system is tested on a regular basis (see your Risk
Assessment). Pushing the red Test System Button will illuminate the LED and flash
the strobes on the panel of the unit plus any units within range and on the same
frequency.
Flashing Strobe = In Range
Green LED = Good Battery
Red LED = Low Battery
Pushing Reset Button (black) will take the units out of test mode.
(Please remember to wait a minimum of 80 seconds before a Test/Activation can be
run)
System
Reset
On/Off
Switch
Main
Activation
Test System
Battery LED
