www.evacuatoralarms.com
Device Numbering Synergy Board
As you can see above there are 3 dials, dial 1 on the left is
NOT
needed for device numbering. Dial 2
and 3 are used for your device numbering, as you can see dial 2 is set to 0 and dial 3 to number 3.
This makes the device number 03. to set a device to number 20 for example dial 2 would be set to 2
and dial 3 set to 0.
Note: When setting the dials, please use the setting driver supplied
Zone Dial (Dial 1)
This dial is factory set to "0" and will not need to be changed unless you wish to separate a number
of systems that will be operating within 2km of each other. This will be used for example if there are
several contractors using the system on the same site or in the same area. It may also be beneficial
to separate zones for floors on larger projects.
Device Dials (Dial 2 and 3)
These dials are used to number the Devices as above. Dial 2 will only be used from 0-4, Dial 3 will use
0-9.
Please Note
–
This PCB will always need to be set to Device number 01, this allows communication
between the Synergy and Zone Master PCB
