38
I.
Place the wallbox on a smooth flat
surface.
II.
Place a wide-head screwdriver (for
example T30) into the slot of the
knockout that is to be removed.
III.
Hit the end of the screwdriver with a
hammer to shear the knockout. Re-
move the rest of the knockout by hand
if necessary and make sure that there
are no burrs present.
2.
Mount cable glands and route cables:
If the holes needed for cable routing
are already sealed with blind plugs, remo-
ve these blind plugs using a pair of pliers.
c.
Optionally, remove knockouts.
It is recommended to remove the
bottom break-out tab and route the
supply cable through the bottom tab (if
applicable).
English
Warning
Leaving sharp edges after removing the
break-out tabs can cause damage to the
cables which could result in the risk of
electric shock, which could cause severe
injury or death.
› Make sure that no sharp edges are left
after removing the break-out tabs.
Warning
Removing more knockouts and/or blind
plugs than necessary for cable routing and
leaving open holes will affect the protecti
-
on against moisture of the wallbox, which
could result in the risk of electric shock,
which could cause severe injury or death.
› Only remove the knockouts necessary for
cable routing.
› Seal open holes with blind plugs if they
are not necessary for cable routing.
Warning
Not using round cables for installation and
mounting the sealing nuts of the cable
glands incorrectly will affect the protec
-
tion against moisture of the wallbox,
which could result in the risk of electric
shock, which could result in a risk of injury
or death.
› Use round cables for installation.
› Make sure that the sealing nuts are
mounted on the outside of the wallbox.
Summary of Contents for Audi Wallbox
Page 1: ...1 Audi Wallbox Installation and User Manual Powered by EN ...
Page 3: ...2 English ...
Page 14: ...13 13 ...
