EVCO S.p.A.
EVlinking Wi-Fi | Installer manual ver. 4.0 | Code 144IF25TWXE404
page 5 of 18
2
DESCRIPTION
2.1
Description EVIF25TWX
Part
Description
1
Pico-Blade connector (TTL MODBUS port)
2
Red LED (MODBUS communication status)
3
Green LED (Wi-Fi communication status)
4
Plug-in screw terminal block (independent power supply)
2.2
Description EVIF25SWX
Part
Description
1
Plug-in screw terminal block (RS-485 MODBUS port)
2
Red LED (MODBUS communication status)
3
Green LED (Wi-Fi communication status)
3
MEASUREMENTS AND INSTALLATION
Measurements in mm (inches); to be fitted to a hard surface with a cable tie
(not provided).
3.1
Measurements
and
installation
EVIF25TWX
3.2
Measurements
and
installation
EVIF25SWX
INSTALLATION PRECAUTIONS
-
Ensure that the working conditions are within the limits stated in
the TECHNICAL SPECIFICATIONS section
-
Install the device where the Wi-Fi signal is strong
-
Do not install the device close to metal parts which may impede
Wi-Fi communication
-
Do not install the device close to heat sources, equipment with a
strong magnetic field, in places subject to direct sunlight, rain,
damp, excessive dust, mechanical vibrations or shocks
-
In compliance with safety regulations, the device must be installed
properly to ensure adequate protection from contact with electrical
parts. All protective parts must be fixed in such a way as to need
the aid of a tool to remove them
