EVCO S.p.A.
Vcolor 869/879
| Installer manual ver. 2.2 | Code 144VC869E214
page 33 of 94
7.5
Setting the set points
7.5.1
Setting the cabinet temperature set point
When selecting a continuous or customized blast chilling or blast-freezing cycle, the pre-set cabinet temperature, product
temperature, time and fan speed values when the parameters were set are loaded. These can be modified by the user
within the permitted range for the parameters. To make a modification press the
key next to the value to be edited.
The screen shown below will appear and the editable value will become orange.
Set the desired value using the
key. Once set-up is complete press the
next to the edited value and
return to the previous screen.
7.5.2
Setting the product temperature set point
Proceed as described for the cabinet set point, after pressing area
for the product temperature (or the temperature
indicated by the needle probe).
7.5.3
Setting the cycle duration
Proceed as described for the cabinet set point, after pressing area
for the cycle duration.
7.5.4
Setting the fan speed
Proceed as described for the cabinet set point, after pressing area
for the fan speed.
The minimum fan speed value that can be set for all cycles (except for slow cooking) is given by parameter F53.
The minimum fan speed value that can be set for slow cooking is given by parameter F54.