EVE
Audio product manual
Speaker Posit Rubber Feet
15
POSITIONING
are printed on the unit underneath the IEC connector.
3.18.
Power Connector (IEC)
Use the power cord supplied to connect your EVE Audio monitors to the
power grid. The IEC connector includes an integrated fuse. If your EVE
Audio monitors stop working and the fuse seems to be the problem,
proceed as follows:
•
Turn the loudspeaker off.
•
Disconnect it from the power grid.
•
Detach the IEC connector from the unit.
•
Remove the fuse.
•
Change the fuse. The replacement fuse should comply with the values
stated on the subwoofer.
4.
POSITIONING
4.1.
Speaker Posit Rubber Feet
Ideally, there should be no objects or obstacles between the loudspeakers
and the listening position. Furthermore, a symmetrical positioning is
important. This applies to the distance between speakers as well as to the
walls, ceiling and floor. In order to have a symmetrical stereo image it is
also important to have symmetrical reflections. We recommend to keep
a distance of at least 0.5 m (19 inches) to the walls, in order to avoid low
frequency boosting.
EVE Audio monitors can also be flush-mounted in a wall, in which case
there should be enough air flow. This is important to keep the electronic
components cool but also to allow for the best performance of the bass
reflex ports. We recommend to keep at least 3 cm (1 in) to the sides and
top.
The SC4070 monitor was designed to be placed vertically or horizontally.
The best position in each case will be determined by the room and the
system used. By default, your monitor is adjusted to be placed horizontally.
To use it in vertical position, turn the tweeter/mid-driver section 90º. Follow
the procedure indicated in the “Horizontal/Vertical Orientation” section.
Finally, fix the supplied rubber feet to the bottom side of the monitor and
place it on an even and stable surface.
Rubber feet: your EVE Audio monitors are supplied with four self-adhesive
rubber feet. Fix them to the bottom of your loudspeakers to place the