EVE
Audio product manual
Filter
11
OPERATION
!
To exit the System Mute mode simply turn the System Volume control
clockwise until you reach the desired volume.
!
In case the subwoofer is connected to an EVE Audio SC203 Master/Slave
system via the dedicated RCA Unbalanced in, the System Volume control
will switch the subwoofer to Mute mode but not the satellites.
3.5.
Settings Menu
Additional status LEDs on the front panel plus infrared sensor
Press the System Volume control once to enter the Settings menu. Here
you can set two different filters (Sat. Filter and Sub Filter), as well as the
phase of the subwoofer and the behavior of the volume controls’ LED
rings. The LED of the currently active function will blink.
Turn the System Volume control to choose the filter, phase or LED mode
desired. The blinking LED indicates the function selected, while the steady-
on LED indicates the value assigned to that function.
Press the System Volume control to confirm your selection. The blinking
will stop once the selection is confirmed.
Turn the System Volume control to adjust the filter, phase or LED behavior.
When you are satisfied with the setting press the System Volume control
again to go back to the Settings menu. You can then select and edit
another function.
!
To exit the Settings menu press and hold the System Volume control for
three seconds or simply wait 10 seconds. The subwoofer will then return
automatically to the Volume mode.
3.6.
Filter
The filters of the EVE Audio subwoofer were specially developed to offer
you the possibility of adjusting your subwoofer to the characteristics of
your system. These filters help control the overlapping of frequencies
