EVE
Audio product manual
DIP Switches
15
OPERATION
system via the dedicated RCA Unbalanced in, the Mute button will mute
the subwoofer but not the satellites.
3.13.
Power Switch
The power switch on the rear panel disconnects the subwoofer completely
from the power grid. When powered off all settings are saved and the
power consumption is reduced to 0 watts.
After powering on again, the subwoofer will return to the state it was in
before being turned off (Standby mode, Mute mode or a given volume
level). Even if powered off via a multiple outlet power strip, the subwoofer
will return to the state it was in before being turned off.
!
In order to prevent switching noise with your monitoring system, keep in
mind the following rules:
Power all audio sources on first, then the subwoofer and then the satellites.
When turning off your system, power off the satellites first, then the
subwoofer and finally all audio sources.
3.14.
DIP Switches
On the rear panel of your EVE Audio subwoofers you will find four DIP
Switches. These allow you to secure your subwoofer settings to prevent
them from being changed inadvertently.
•
Filter Lock
When set to “On,” this DIP Switch secures the current filter settings. The
filter settings can be read on the LED ring of the System Volume control on
the front panel, but they cannot be modified. When set to “Off,” the filters
can be modified freely.
•
Volume Lock
When set to “On” this DIP Switch secures the current volume settings. The
LED rings on the front panel indicate the volume settings of the subwoofer
and the satellites (connected to the subwoofer via the XLR outs), but they
cannot be modified. When set to “Off,” the volume setting can be changed
by simply turning the knob.
•
Auto On/Off
When set to “On”, this DIP Switch enables the auto-standby mode. This
function automatically switches the subwoofer to standby when no input
signal was detected for 10 min in both XLR and RCA inputs. The system
is automatically switched on again as soon as an input signal is detected
