If you are connecting to a dishwasher, complete the following step
.
If a dishwasher is not to be connected go on to
"
Attaching the Discharge Elbow
"
section
DISHWASHER CONNECTION (IF REQUIRED)
1. KNOCK OUT PLUG
Using a blunt instrument steel punch or wooden
dowel knock out entire plug Do not use a screwdriver or sharp
instrument When knockout plug falls into disposer you may
remove it or simply grind it up when the disposer is used This will
not damage the disposer in any way but may take some time to
grind over the course of several uses
Knock out the
plug
2. CONNECT HOSE
Connect the dishwasher hose using a hose clamp If the hose
size is different, you will need a stepped
rubber adapter
Hose Clamp
Stepped Rubber
Adapter
3. ATTACHING THE DISCHARGE ELBOW
CONNECT DISCHARGE ELBOW
*
Connect the discharge elbow to the disposer
Make sure all plumbing connections are tight
Discharge Elbow
ยางโอริง
*
Discharge elbow must be installed by a
professional
.
**
Some installations
(
see page 8 for examples
)
may require the use of a flexible drain pipe
.
NOTE:
If the dishwasher connection is made
without removing the plug, the dishwasher may
overflow
.
Rubber Gasket
Summary of Contents for FWD560+
