A. CARRY HANDLE
B. WATER TANK
C. HUMIDIFIER HOUSING
D. 1Touch
™
CONTROL PANEL
E. HUMIDIFIER BASE
F. FILTERCARE™ INDICATOR
OPERATING INSTRUCTIONS
Your humidifier is equipped with a technologically advanced
1 Touch™ Electronic Humidistat. You can set the humidifier
to run continuously in manual mode or set the 1 Touch™
Electronic Humidistat to your desired humidity setting.
The 1 Touch™ Electronic Humidistat will automatically turn
the humidifier ON or OFF, depending on the preset comfort level.
The comfort level ranges between 35% and 55% relative humidity.
MANUAL MODE INSTRUCTIONS:
1. Plug the humidifier into a 120V AC electrical outlet.
2. To start the unit, push the MODE/OFF button once for
the HIGH (II) manual setting. (See fig. #1)
3. Press the button again for the LOW (I) manual setting.
(See fig. #1)
4. To stop the unit, press and hold the button for two seconds, or
keep pressing the button until all the humidity indicators are OFF.
1 TOUCH HUMIDISTAT INSTRUCTIONS
To take advantage of the 1 Touch™ Electronic Humidistat, press the
MODE/OFF button until the speed is set in either the HIGH or LOW
setting, and the Desired Humidity is set. When the humidity level
rises above the set humidity, the humidifier will stop. When the
humidity level drops below the set humidity, the humidifier will turn
on automatically.
NOTE: When the 1 Touch™ Electronic Humidistat is set, either the
HIGH or LOW power light and the percent humidity light will remain
lit during operation. (See fig. #1)
NOTE: Allow up to 30 minutes for the filter to fully absorb water
and for the unit to produce moisture.
NOTE: The 1 Touch™ Humidifier has memory. This means that when
you turn the unit back on, it will be at the last setting the humidifier
was set at.
If you do not plan to use the humidifier for two or more days, make
sure any residual water is drained from the water tank, base and
wick filter to prevent algae or bacteria growth.
CLEANING AND SERVICE INSTRUCTIONS
Humidifiers provide comfort by adding moisture to dry, heated indoor
air. To benefit most from the humidifier and avoid product misuse,
follow all instructions carefully. Please note that this is an electrical
appliance and requires attention when in use.
In addition, if you do not follow the recommended care and
maintenance guidelines, micro-organisms may be able to grow
in the water within the Water Tank. You must routinely follow
the cleaning procedures that follow in order to ensure proper,
efficient operation of your humidifier. Proper maintenance
and cleaning is essential to the continued performance of
your unit and the avoidance of algae or bacteria build-up.
DAILY MAINTENANCE
1. Be sure the unit is OFF and is disconnected from the electrical outlet.
2. Remove the housing and the tanks from the humidifier and place
them in sink or tub.
3. Carry the base of the unit to the sink, remove the wick filter, place in
sink, drain any remaining water and rinse thoroughly to remove any
sediment or dirt. Wipe clean, and dry with a clean cloth or paper towel.
4. Drain the water from the tanks into the sink and rinse each tank
thoroughly. Wipe clean, and dry with a clean cloth or paper towel.
5. Put filter back in the filter supports, replace the housing, then refill
the tanks with cool tap water as instructed earlier in the Filling
Instructions. Do not overfill.
6. Follow Operating Instructions.
WEEKLY MAINTENANCE
To Remove Scale:
1. Repeat steps 1-4 above.
2. Partially fill the base with Cleanse Clean™ (Model S1710)
as instructed on bottle, or with two 8 oz. cups of undiluted white
vinegar. Leave this solution in the base for 20 minutes, while cleaning
all interior surfaces with a soft brush. Remove base scale by wiping
the base with a cloth dampened with undiluted white vinegar.
3. Rinse with clean warm water to remove the cleaning solution
before disinfecting the tank.
To Disinfect Humidifier Base Tanks:
1. Fill Humidifier Base with 2 gallons of water and 1/2 teaspoon
of chlorine bleach.
2. Fill each tank1/2 full with water and 1 teaspoon of chlorine bleach.
3. Let the solution stand for 20 minutes, swishing every few minutes.
Wet all surfaces.
4. Carefully empty the Base and Tanks after 20 minutes, and rinse with
water until you cannot detect any bleach smell. Dry with a clean cloth
or paper towel.
5. Check the FilterCare™ indicator to see if it is time
to replace the filter. Depending on the water hardness in your
area, it may be necessary to change the filter every 1-2 months.
Re-insert the wick filter into the filter support.
6. Refill the water tanks as directed with cool tap water, replace
the humidifier housing, and turn the Control button to ON.
WHEN USING ELECTRICAL APPLIANCES, ESPECIALLY WHERE
CHILDREN ARE PRESENT, YOU SHOULD ALWAYS FOLLOW
THESE BASIC PRECAUTIONS TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK AND INJURY TO PERSONS:
1. Read all instructions before using the appliance.
2. To avoid fire or shock hazard, plug the appliance directly
into a 120 V AC electrical outlet.
3. Keep the cord out of heavy traffic areas. To avoid fire hazard,
NEVER put the cord under rugs, near heat registers, radiator,
stoves, or heaters.
4. DO NOT place humidifier near heat sources such as stoves,
radiators, and heaters. Do locate your humidifier on an inside
wall near an electrical outlet. The humidifier should be at least
4" away from the wall for best results.
5. NEVER place humidifier in an area where it is accessible to
children. NEVER use humidifier in a closed room, particularly
where a child may be sleeping, resting, or playing (a closed
room may result in excessive humidity).
6. WARNING: DO NOT attempt to refill humidifier without first
unplugging the unit from it’s electrical outlet. Failure to heed
this warning may cause personal injury. Be sure to pull the
plug and not the cord.
7. Never place anything over moisture outlet when the unit
is running.
8. NEVER drop or insert any object into any openings.
9. DO NOT operate any appliance with a damaged cord or plug,
after the appliance malfunctions, or if it has been dropped or
damaged in any manner. Return appliance to manufacturer
for examination, electrical or mechanical adjustment, or repair.
10. Use appliance only for intended household use as described
in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, or injury to
persons. The use of attachments not recommended or
sold by Evenflo
®
may cause hazards.
11. DO NOT use outdoors.
12. Always place humidifier on a firm, flat, level surface.
A waterproof mat or pad is recommended for under the
humidifier. NEVER place it on a rug or carpet, or on a finished
floor that may be damaged by exposure to water or moisture.
13. DO NOT allow the Moisture Outlet to directly face the wall.
Moisture could cause damage, particularly to wallpaper.
14. Humidifier should be unplugged when not in use.
15. NEVER tilt, move, or attempt to empty unit while it is operating.
Shut off and unplug before removing the water tank and moving
the unit.
16. This humidifier requires daily and weekly maintenance to operate
appropriately. Refer to daily and weekly cleaning procedures.
17. NEVER use detergents, gasoline, glass cleaner, furniture polish,
paint thinner, or other household solvents to clean any part
of the humidifier.
18. Excessive humidity in a room can cause water condensation
on windows and some furniture. If this happens, turn the
humidifier OFF.
19. DO NOT use humidifier in an area where humidity level is
in excess of 50%.
20. DO NOT attempt to repair or adjust any electrical or mechanical
functions on this unit. Doing so will void your warranty. The
inside of the unit contains no user serviceable parts. All servicing
should be performed by qualified personnel only.
21. Never place housing under water flow or immerse in liquids.
22. DO NOT plug in the cord with wet hands: electric shock
could result.
23. DO NOT pour water in any openings other than the water tank.
24. To prevent damage to surfaces, do not place humidifier under
overhanging surfaces.
PLEASE READ AND SAVE
THESE IMPORTANT
SAFETY INSTRUCTIONS
Thank you for choosing a Evenflo
®
Cool Mist humidifier.
To ensure the best performance from your humidifier, please read
and save the following instructions.
Consumer Safety Information
Note: This is an electrical appliance and requires attention
when in use.
Note: If moisture forms on the walls or windows of the room, turn
off the humidifier. The room already has plenty of humidity and
additional moisture may cause damage.
Cord and Plug Installation Safety Instructions
The length of cord used on this appliance was selected to reduce the
hazards of becoming tangled in, or tripping over a longer cord. If
a longer cord is necessary an approved extension cord may be used.
The electrical rating of the extension cord must be equal to or greater
than the rating of the humidifier. Care must be taken to arrange the
extension cord so that it will not drape over the countertop or tabletop
where it can be pulled on by children or accidentally tripped over.
THIS PRODUCT IS EQUIPPED WITH A POLARIZED AC
(Alternating Current)PLUG (a plug having one blade wider
than the other). This plug will fit into the power outlet only
one way. If the plug does not fit fully into the outlet,
reverse the plug. If it still does not fit, contact qualified
personnel to install the proper outlet.
DO NOT DEFEAT THE SAFETY PURPOSE OF THIS
POLARIZED PLUG IN ANY WAY.
REPLACING THE FILTER
Through normal use, waterborne minerals and sediment become
trapped in the wick filter. The harder your water, the greater the
amount of minerals in the water, and the more often you will need
to change your filter.
You will be able to monitor the life
of the filter in your humidifier
by checking the FilterCare™
Indicator. When the unit is off,
the FilterCare™ Indicator will
read in the OFF position. After
60 minutes of use, FilterCare™
Indicator (refer to fig. 3 for
close-up of indicator) will move from the OFF position and indicate
your filter condition. A brand new filter will register in the section
reading GOOD filter. After frequent use of your humidifier, the
FilterCare™ Indicator will let you know when the filter needs
to be changed.
When the needle is in the (CHANGE) section, this means the proper
amount of moisture is not getting into your air due to the excessive
minerals and sediment that have become trapped on your filter. At
this point, you should replace your filter. It is important
to change your filter as indicated to obtain stated performance level.
To replace the filter, follow the steps below.
1. Push the 1 Touch™ button for 2 seconds to turn the unit
OFF and disconnect from the electrical outlet.
2. Remove the tank and main housing to access the base tray.
3. Discard the old filter and follow weekly cleaning instructions.
4. Insert a new filter into the filter support in the base.
5. Replace the main housing and then the tank.
6. Repeat Operating Instruction steps.
It will take about 30 minutes for the humidifier to reach
maximum output.
You can obtain a new filter by calling 1-800-546-5637 in the USA
or by visiting your nearest retailer or authorized service center.
This humidifier takes model 755001 replacement filter.
A
F
E
D
C
B
Figure 1
A. CIRCULAR EXTENDED
LIFE FILTER
B. CIRCULAR FILTER
SUPPORT
C. FLOAT SWITCH
D. HUMIDIFIER BASE
A
C
B
D
Figure 2
HOW COOL MIST WORKS
Your Evenflo
®
Cool Mist humidifier draws dry air through
the rear air intake grill area. This air is then passed through
a moisture–laden wick filter, which retains the minerals and
deposits in the water.
The resulting moist air is directed back into the room from
the top air grill.
NOTE: This humidification system provides a cool, invisible
moisture output. It is normal not to see the mist.
NOTE: A humidity level below 20% can be unhealthy and
uncomfortable. The recommended humidity level is between
40%-50%.
PRE-OPERATING INSTRUCTIONS
1. Be sure the unit is OFF and is disconnected from
the electrical outlet.
2. Select a location for your humidifier, on a flat surface, about
4" away from the wall. Do not place your humidifier on furniture;
a floor location that will not be damaged by moisture is best.
3. Remove the water tank by holding the carry handle and lifting
straight upward (see figure 1).
4. Remove the main housing by lifting straight upward. Check
to see that the wick filter is properly in place. Replace the
humidifier housing.
FILLING THE WATER TANK
NOTE: This humidifier holds about 1 gallon of water in the tank
and humidifier base. The humidifier will produce up to 3 gallons
of moisture over a 24-Hour period, depending on the room humidity
and temperature.
1. Be sure the unit is OFF and is disconnected from the electrical
outlet.
2. Remove the tank from the base by holding the handle
and lifting straight up (see figure 1).
3. Twist off the tank cap located on the bottom of the tank by
turning counter clockwise and fill the water tank with cool,
fresh water.
Do not fill with warm water as this may cause leaking.
4. After filling the tank, replace the tank cap by firmly turning
clockwise and then replace the water tank on the base.
The tank will immediately begin to empty into the base.
5. Plug the power cord into a 120V AC electrical outlet.
Figure 3
P L E A S E R E A D A N D S A V E T H E S E I M P O R T A N T
S A F E T Y I N S T R U C T I O N S
759200 COOL MIST HUMIDIFIER
