12
13
M
A
6.
Press assembled seat ring down firmly onto the top of
the tray until it snaps into place and spins freely.
Assembling the ExerSaucer
5.
Turn seat ring right side up.
Align triangles on the back of the seat ring with the
triangles on the seat pad label.
Snap the plastic tabs on the pad over the pegs on the
seat ring.
Continue this process until all tabs are attached to
all pegs, then push the seat pad down inside the seat ring.
J
K
L
I
F
F
Assembling the ExerSaucer
4.
Place seat ring upside down and locate the wheel
holders . Snap six (6) seat wheels into wheel
holders, as shown.
F
B
H
G
2.
Locate (3) feet on underside of tray .
Remove foot by squeezing tab as shown.
3.
Align slots in foot with tabs on leg . Snap foot onto leg.
Repeat until all three (3) feet are installed on legs. Pull foot to
make sure it is locked onto leg.
D
A
D
E
D
B
To adjust height:
ALWAYS
remove baby from ExerSaucer before adjusting.
Push button until the desired position is obtained. Make
sure that all three legs are adjusted to the same position.
To avoid injury, allow the baby’s toes only to touch the floor.
DO NOT
allow the baby to stand flat-footed on the floor.
As baby grows and becomes more active, raise the tray to
the next level so that baby enjoys the most comfortable fit
and maximum use of the spin, and bounce features.
WARNING
N
N
Summary of Contents for ExerSaucer Fast Fold Go
Page 46: ... ...
