3
2
Assembling the ExerSaucer
Assembling the ExerSaucer
3.
Locate the other two pylons
B
.
One at a time, turn them
upside down and completely insert the end of a stabilizer
tube
A
in each pylon, as shown.
Make sure the stabilizer tubes are fully inserted into the
bottom of each pylon.
5.
Insert a foot
C
into the bottom of each pylon
B
, as
shown. Secure each foot with one 8-16 X 75 mm screw
D
and four 8-16 X 18 mm screws
E
. Tighten all 10 screws
securely but
do not overtighten
.
DO NOT USE POWER
TOOLS.
IMPORTANT:
Each foot
MUST
sit completely flat in the
BOTTOMOFTHEPYLON)FITISRAISEDONEITHERENDTHENONEOF
the stabilizer tubes is not installed correctly or is not fully
INSERTED)FTHISISTHECASEREMOVETHESTABILIZERTUBEAND
reinstall until the foot fits over it correctly.
2.
Insert a foot
C
into the bottom of the pylon
B
, as shown.
Secure with one 8-16 X 75 mm screw
D
and four
8-16 X 18 mm screws
E
. Tighten all five screws securely but
do not overtighten
.
DO NOT USE POWER TOOLS.
IMPORTANT:
The foot
MUST
sit completely flat in the bottom
OFTHEPYLON)FITISRAISEDONEITHERENDTHENONEOFTHE
stabilizer tubes is not installed correctly or is not fully inserted.
)FTHISISTHECASEREMOVETHESTABILIZERTUBEANDREINSTALLUNTIL
the foot fits over it correctly.
4.
Locate the third stabilizer tube
A
and insert into both
pylons
B
, as shown.
Make sure the stabilizer tube is fully inserted into the
bottom of each pylon.
B
A
B
A
A
B
E
E
C
D
6.
Place seat ring
F
upside down and
locate the wheel holders
G
.
Snap four seat wheels
H
into wheel
holders, as shown.
F
B
H
G
E
E
C
D
B
B
7.
Turn seat ring
F
right side up.
Align the two
triangles
on the
back of the seat ring with the two
triangles
on the label on the seat
pad
I
.
Snap the plastic tabs
J
on the pad
over the pegs
K
on the seat ring.
Continue this process until all tabs
are attached to all pegs.
K
K
J
J
Triangles
I
L
F
B
E
E
C
D
