29
28
D
6
• To avoid a strangulation hazard, you
MUST
tightly roll or
fold excess tether strap and secure with the strap/
rubber band.
• Attach the tether hook to the storage clip when not in
use. This will keep an unused tether from hitting
someone during a crash.
WARNING
After adjusting the top tether strap, you may have
excess strap;
DO NOT
cut it off. If you do, it may not be
long enough to use in another vehicle. Instead,
tightly
roll up the excess tether strap and place the rubber
band around the bundle.
Note:
Refer to your
vehicle owner’s manual
for the
location of the tether anchor bracket in your vehicle. Older
vehicles may not come equipped with anchor bracket
hardware. Check with your vehicle dealer.
If you have questions regarding tether anchors that are not
addressed by the vehicle owner’s manual or answered by
an authorized dealer/vehicle manufacturer, call Evenflo’s
ParentLink at 1-800-233-5921 (U.S.) or 1-937-773-3971
(Canada), or 01-800-706-12-00 (Mexico).
E
F
G
7
WARNING
• Failure to follow these instructions could result in serious
injury to your child or other vehicle occupants.
• The tether strap is for
forward-facing use only
.
WARNING
The vehicle seat belt must be as tight as possible.
Using your full weight, push the child restraint firmly
into the vehicle seat as you tighten the vehicle belt. If
you can move the child restraint more than 25 mm (1
in.) side to side or front to back at the forward-facing belt
path
D
, the seat belt is
not tight enough
, you will need
to
try again
, or install with the lower anchor connector
assembly (page 30).
• If vehicle seat belts are not routed and fastened correctly,
the child restraint may not protect your child in a crash.
•
Check your vehicle owner’s manual to determine how to
lock your seat belt for child restraint installation. The seat
belt must be locked to properly secure the child restraint.
•
DO NOT
use this child restraint if it moves more than 25
mm (1 in.) side to side or front to back at the
forward-facing belt path
D
. Serious injury or death may
result from poor installation. If you can not tightly secure
the child restraint, try again or move it to another
location, or install with the lower anchor connector
assembly (page 30).
Connect the tether
hook
E
to the vehicle
tether anchor
F
behind
the vehicle seat, as
shown. (Please consult
your vehicle owner’s
manual, as tether anchor
locations may vary.) Pull
the strap
G
and tighten
the tether securely.