__________________________________________________________________________________________________________________
Series GA201-M2
11
LT126 June 2021
Assembly
1. Disassemble shipped parts and separate the hardware packages. Start with the heater base unit and the
heater head assembly as shown in Figure 3.
2. Remove the screws from the burner head assembly (4 screws). Insert the gas supply hose into the pole
neck. The hose will slide down the pole until the head assembly sits in the pole neck.
Figure 3: Heater Base and Heater Head Assemblies
3. Rotate the head assembly so the EvenGlo label on the heater head lines up with the EvenGlo label on the
Main Base.
Figure 4: Location of Front Control Knob
4. Use the screws that were removed in Step 1 to secure the burner assembly to the pole neck assembly (4
screws).
