__________________________________________________________________________________________________________________
Series GA201-M2
3
LT126 June 2021
CAUTION AND GENERAL SAFETY
CAUTION - FIRE OR BURN INJURY HAZARD
WARNING
Do not install or place on a table or on an inclined surface, make sure the installation surface is level before
installing the heater.
•
Assembly & Installation will require the efforts of Two individuals, it is not recommended for only One
Person to attempt complete assembly of the Heater.
•
At all times maintain clearance to combustible materials as further specified in this manual. Failure to do so can
result in serious fire hazard.
•
Never operate Heaters in atmosphere containing flammable vapours or combustible dusts.
•
This Heater is equipped with an electronic ignition device. Do not attempt to light the burner by hand. Failure to
comply can result in a serious fire and personal injury hazard.
•
Heater surfaces, other than the obvious flame and emitter surfaces, attain elevated temperatures during operation.
Do not touch
the heater head during operation.
•
Certain materials, when stored under this Heater are subjected to radiant heat can soften, distort or otherwise be
damaged; special care should be taken of plastic materials
•
Children and adults should be alerted to the hazards of high surface temperatures and should stay away
to avoid burns or clothing ignition.
•
Young children should be supervised when they are in the area of the heater.
Playing or running around the
heater should be strictly forbidden.
•
Clothing or other flammable materials should not be hung from the heater or placed on or near the heater.
•
Any guard or other protective device removed for servicing the heater must be replaced prior to operating
the heater.
Replacement pressure regulators and hose assemblies must be those specified by the manufacturer.
•
Installation and repair should be done by a qualified / certified service person. The heater should be
inspected before use and at least annually by qualified service person.
(Service person must be ‘Certified’
by the local / national regulating body).
•
Frequent cleaning may be required. It is imperative that Burners and circulating air passageways of the heater be
kept clean of debris, dust and insects.
•
Cleaning of the heater should only be done with non-combustible and non-corrosive cleaning agents. DO NOT
alter the heater in any way; this includes shortening the pole or removing the Base Body cover or Top Reflector.
•
NEVER paint the Burner, Emitter, Shield Support Arms or the Reflector.
•
The visible portion of the Hose Assembly must be visually inspected before each use. If there is evidence of
excessive abrasion or wear, or if the hose is damaged the hose assembly must be replaced prior to the heater
being put into operation.
