©2000 Eventide Inc.
DIR911 Instant Recall Recorder
19
When ALI data are available, the DIR911 can extract the telephone number
identification of the calling party from these data. You will need to set the line #, column
#, and the length of the incoming caller’s phone number. Here is an example of ALI
data and how you would set those three quantities:
WARNING-LINE
201-641-1200
HH:MM:SS
MM/DD/YY
CITIZEN’S
NAME
STRNUM
TRL
PRE
STREET
NAME
STREET NAME CONT D SUFX DIR
MAP
COORDINATE
COMMUNITY ST
BUILDING
ID
UNIT FLR CLAS
PILOT # NPA-NXX-XXXX ESN
PSAP
IDENTITY
LAW NPA-XXX-XXXX
FIRE NPA-XXX-XXXX
EMS NPA-XXX-XXXX
CF # NPA-XXX-XXXX LEC
If the ALI data received by the DIR911 are in the above form, set the line number to 2
for the 2
nd
line, the column number to 1 for the 1
st
char of the 2
nd
line, and set the length
to 12 for all numbers including the dashes, e.g., 201-641-1200. The dashes MUST be
included in the length of the number so the entire number can be scanned by the
DIR911.
NOTE: The format of ALI data changes from state to state, and sometimes from county
to county. You will need to verify the format for your particular location.
The DIR911 will extract the calling party’s number when receiving ALI even if the unit
does not have the extra memory option installed. However, these data will NOT be
stored in the DIR911 system memory and will not be available on playback. The extra
memory option MUST BE INSTALLED FOR FULL ALI DATA SUPPORT.
UPGRADE Screen
-
Field firmware upgrade
The DIR911 firmware can be upgraded in the field provided that you have a computer
with a serial download program. The upgrade process is a two-step process, which
Line #: 01 Column #: 01 Length: 10
Set the location in the ALI data stream
to correspond to the incoming phone #
LINE COLUMN LENGTH DONE
You must LOAD the new firmware first
SAVE next to save in ROM version
DO NOT PRESS UNTIL UPGRADE PREPARED
LOAD SAVE QUIT
