EVER POWERLINE DARK 33 10 - 40 kVA UPS Operating Manual
Type 01 2019-06-10 14:36
Technical Assistance, phone: +48 61 6500 400
18
38 Battery Test Fail-Set
Battery test failed
39 Battery Maintenance-Set
Battery Maintenance Starts
40 Batt Maintenance OK-Set
Battery Maintenance succeeds
41 Batt Maintenance Fail-Set
Battery Maintenance fails
42 Rectifier Fail-Set
Rectifier damaged
43 Rectifier Fail-Clear
End of the message
44 Inverter Fail-Set
Inverter circuit defective
45 Inverter Fail-Clear
End of the message
46 Rectifier Over Temp.-Set
Rectifier temperature excessively high
47 Rectifier Over Temp.-Clear
End of the message
48 Fan Fail-Set
Fan failure
49 Fan Fail-Clear
End of the message
50 Output Overload-Set
UPS overloaded
51 Output Overload-Clear
End of the message
52 Inverter Overload Tout-Set
Power module overload timeout
53 INV Overload Tout-Clear
End of the message
54 Inverter Over Temp.-Set
Rectifier temperature excessively high
55 Inverter Over Temp.-Clear
End of the message
56 On UPS Inhibited-Set
Prohibited switch from bypass to mains (normal) mode
57 On UPS Inhibited-Clear
End of the message
58 Manual Transfer Byp-Set
Manual switch to bypass
59 Esc Manual Bypass-Set
Manual deactivation of bypass
60 Battery Volt Low-Set
Batteries low
61 Battery Volt Low-Clear
End of the message
62 Battery Reverse-Set
Battery polarisation reversed
63 Battery Reverse-Clear
End of the message
64 Inverter Protect-Set
Inverter protection (against incorrect output or reverse voltage)
65 Inverter Protect-Clear
End of the message
66 Input Neutral Lost-Set
No neutral lead
67 Bypass Fan Fail-Set
Bypass fan failure
68 Bypass Fan Fail-Clear
End of the message
69 Manual Shutdown-Set
Power module manual shutdown
70 Manual Boost Charge-Set
Forcing batteries to charge in boost mode
71 Manual Float Charge-Set
Forcing batteries to charge in float mode
72 UPS Locked-Set
UPS cannot be switched off.
73 Parallel Cable Error-Set
Cables for parallel operation connected improperly
74 Parallel Cable Error-Clear
End of the message
75 Lost N+X Redundant
No redundant units
76 N+X Redundant Lost-Clear
End of the message
77 EOD Sys Inhibited
System is inhibited to supply after the battery is EOD (end of discharging)
78 Power Share Fail-Set
Uneven power distribution
79 Power Share Fail-Clear
End of the message
80 Input Volt Detect Fail-Set
Incorrect voltage value in input line
81 Input Volt Detect Fail-Clear
End of the message
82 Battery Volt Detect Fail-Set
Incorrect voltage value in battery line
83 Batt Volt Detect Fail-Clear
End of the message
84 Output Volt Fail-Set
Incorrect output voltage value
85 Output Volt Fail-Clear
End of the message
86 Outlet Temp. Error-Set
Outlet Temperature is abnormal
87 Outlet Temp. Error-Clear
End of the message
88 Input Curr Unbalance-Set
Unbalanced input current
89 Input Curr Unbalance-Clear
End of the message
90 DC Bus Over Volt-Set
Excessively high voltage on the DC bus
91 DC Bus Over Volt-Clear
End of the message
92 REC Soft Start Fail-Set
Rectifier soft start error
93 REC Soft Start Fail-Clear
End of the message
94 Relay Connect Fail-Set
Relay circuit open
95 Relay Connect Fail-Clear
End of the message
96 Relay Short Circuit-Set
Relay short circuit
97 Relay Short Circuit-Clear
End of the message
98 No Inlet Temp. Sensor-Set
Air inlet temperature sensor disconnected or damaged
99 No Inlet Temp Sensor-Clear
End of the message
100 No Outlet Temp. Sensor-Set
Air outlet temperature sensor disconnected or damaged
101 No Outlet TmpSensor-Clear
End of the message
102 Inlet Over Temp.-Set
Inlet air temperature too high
103 Inlet Over Temp.-Clear
End of the message
Summary of Contents for POWERLINE DARK 33 10kVA
Page 1: ......
