5
ELECTRICALPARTS:
。
AC power cord: 6 feet SPT-2 with UL plug
。
Output lead: 6 feet SPT-1 2X18AWG with insulated battery clamps.
ENVIRONMENTALCHARACTERISTICS:
。
Operating temperature range: 32 to 104° F
。
Storage temperature range: 10 to 170°F
。
Operating humidity range: 90% RH Max
ECO MODE:
If AC power is connected, and the battery is not connected, the charger
will automatically go into ECO mode. Input power draw in ECO mode is
less than 1.5W (0.04kWh per day).
Power consumption in maintenance mode is 0.05kWh per day
.
CHARGING INSTRUCTIONS:
STEP 1 - Pre Charge:
Battery & Electrolyte Level Check
。
Check the battery electrolyte level (Only for Flooded or WET
battery).
If necessary, remove the vent caps and add distilled water so the
levels are halfway between the upper and lower fill lines.
。
STEP
2
-
Connect
Charger
to
Battery
。
If
the
battery
is
out
of
the
vehicle
:
。
Connect
the
Red
lead
from
the
charger
to
the
positive
(+)
battery
terminal.
。
Connect
the
Black
lead
from
the
charger
to
the
negative
(-)
battery
terminal.
。
If
battery
is
still
in
the
vehicle
,
determine
if
the
vehicle
is
positively
or
negatively
earthed.
。
If
Negatively
earthed
(Most
Common)
–
First
connect
the
Red
(+)
battery
charger
lead
to
the
Positive
(+)
battery
post
and
then
connect
the
Black
(-)
battery
charger
lead
to
the
vehicle’s
chassis
and
away
from
the
fuel
line.
。
If
Positively
earthed
–
First
connect
the
Black
(-)
battery
charger
lead
to
the
Negative
(-)
battery
post
and
then
connect
the
Red
(+)
battery
charger
lead
to
the
Vehicle’s
chassis
and
far
away
from
the
fuel
line.
STEP
3
–
Connect
Charger
to
Power
(230V
AC
)
。
Connect
the
battery
charger
to
AC
mains
powered
socket.
。
The
Charger
will
automatically
start
when
AC
power
is
connected
and
switched
on.
(Note:
If
the
Fault
Indicator
LED
illuminates
Red,
please
check
your
connections
as
it’s
likely
that
the
Positive
and
Negative
leads
are
reversed.
Refer
to
Trouble
Shooting
page
for
further
information)
Check the battery label - it must be 12V
