SINLINE XL series UPS – Instruction Manual
2010/01/27
www.ever.eu
18
FIRST START
WARNING! The UPS may only be connected to a ~230V mains
socket equipped with a grounding bolt. Electric installation of the
building to which the back-up is connected must be protected
against overloads and shorting.
After unpacking, place the device in the chosen location and connect it to the mains
in order to charge the internal batteries. Charging time of batteries can be found in
the technical parameters table. Afterwards, the user may continue with the
installation procedure. Take the following steps:
•
Turn the UPS off with the power switch on the front panel (only if it was turned
on),
•
connect the devices that require buffer power supply
(e.g. computer and monitor) to the outlet sockets on the UPS,
•
connect the UPS to the computer (if using RS232),
•
turn on the UPS with the switch on the front panel,
•
turn on the devices connected to the UPS,
•
install the monitoring software on the control computer
(see chapter "Installation of the PowerSoft software").
•
connect the UPS to the computer (if using USB),
With all of the above actions complete the UPS is ready for operation.
WARNING! Back-up's batteries reach their full capacity after
approximately a month of mains operating mode.
Summary of Contents for SINLINE XL 1800
Page 1: ......