EASY DECISION
CLEANING
NOTE: Cleaning and maintenance operations must only be carried out when the cooktop is
cool (all residual heat indicators are off).
The appliance should be disconnected from the power outlet or turned off at your isolation
switch before commencing any cleaning process.
Do not use plastic, plastic coated or aluminium cooking equipment on this appliance.
CLEANING THE COOKTOP
All cookware used on this appliance should be rated for induction cooking by the manufacturer.
Cookware with rough bases should not be used as they can scratch the glass ceramic surface. The base of
the good cookware should be as thick and flat as possible. Before use, make sure that cookware bases
are clean and dry.
Always place the cookware on the cooking zone before it is switched on. If possible, always place the lids
on the cookware. The base of any cookware used must not be smaller or larger than the cooking zones;
they should be the proper size as indicated below, so as not to waste energy. If incorrectly placed, the U
symbol will be displayed.
Before cleaning the cooktop, first isolate the cooktop from the power. Once done, ensure that there is
no residual heat stored in the appliance. Vitroceramic glass is very resistant to high temperature and
overheating. If there is residual heat stored in the appliance, the related residual heat indicator lamp will
be on. In order to avoid burns, let the appliance cool down.
Remove all spilt food and fat with a clean damp, warm, slightly soapy, dishcloth. Rinse cloth and wipe
cooktop again until clean, then wipe the cooktop dry with a clean tea towel or dry soft cloth.
If aluminium foil or plastic items are accidentally melted on the vitroceramic surface, they should be
immediately removed from the hot cooking area with a scraper specifically for vitroceramic glass. This will
avoid any possible damage to the surface. This also applies to sugar or food containing sugar that may
be spilled on the cooktop. Enamelled steel, aluminium & copper will leave a residue on the surface that
should be removed immediately or permanent damage may occur.
In the event of other food melted on the cooktop surface, remove the dirt when the appliance has cooled
down. Use cleaner for glass ceramic or stainless steel when cleaning the surface.
Do not use abrasive sponges to clean the vitroceramic surface. These materials may damage the surface.
Do not use chemical detergents, sprays or spot removers on the vitroceramic surface. These materials
may cause fire or the vitroceramic colour to fade. Clean with a damp, warm, slightly soapy, dishcloth.
WARNING: Using cookware that is too large can cause discolouration or damage to the cooktop surface
around the heat zones, which is NOT covered under warranty.
11
11
