EASY DECISION
OPERATING INSTRUCTIONS
The basic layout of the induction cooktop is shown in the diagram below.
The induction cooktop appliance is operated by touching buttons, with the functions confirmed by LED
displays and acoustic signals.
Turning On and Turning Off the Cooktop Appliance
NOTE: Do not operate the cooktop without first placing a suitably sized cooking vessel containing food on
the appropriate cooking zone. Missing or incorrectly sized cookware will cause the “U” fault to be
displayed on the Heat level display (cooking zone off). Turn off the cooking zone or replace cookware to
continue cooking.
If the appliance is in Stand-By-Mode, it is put into Operating-Mode by pressing the On/Off button for at
least 1 second. A beep signal indicates the successful operation acoustically.
On all Heat Level Displays a ´0` will appear and all Decimal Points of the Heat Level displays will flash (1
second on, 1 second off).
If there is no operation within 20 seconds, all the Heat Level Displays will automatically turn off. If the
displays are turned off, the hotplates will be re-set into Stand-By-Mode.
If On/Off is pressed for more than 2 seconds (in Operating-Mode), the appliance is switched off and is set
into the Stand-By-Mode again. The appliance can be turned off by pressing On/Off at any time; even if
other buttons are pressed simultaneously.
If there is a residual heat of a hotplate remaining, this will be indicated in the correspondent heat setting
Heat Level Display as a red “H”.
Selecting A Cooking Zone
Select a single cooking zone by pressing the corresponding Heater Selection Button, and the Decimal Point
of the chosen cooking zone turns on. For the selected cooking zone, you can set or adjust the heat level
between 1-9 by touching the Increase Heat Setting Button or Decrease Heat Setting Button. All of the
other cooking zone displays will have a visible ‘O’ or ‘H’ (if recently used) but they will not have a decimal
point.
If left idle for more than 10 seconds, the decimal point on the chosen cooking zone display will turn off (the
cooking zone is no longer selected). Press the Heater Selection Button again to select the cooking zone
again. Other cooking zones can be selected without waiting for the previous one to become inactive.
The Heat Level Display works on a thermostat system. This means that the cooking zone will switch on and
off in order to remain at the chosen Heat Level. NOTE the cooking zone will remain on for longer periods if
a higher Heat Level is chosen, alternatively the cooking zone will be on less regularly on lower Heat Level
Settings.
8
Heater
Display
U
pper left
heater selection
Lower
Right
heater selection
Decrease
heat setting
Boost
L
ower left
heater selection
Key Lock
Indicator
On/Off
Smart Pause
Increase
Heat setting
Upper
Right
heater selection
