EASY DECISION
Turning Off Individual Cooking Zones
A particular cooking zone can be turned off in 2 different ways:
A) Selecting the cooking zone & then simultaneously pressing the Increase Heat Setting Button and
Decrease Heat Setting Button, after which a beep signal sounds and “0“ appears in the Heat Level Display.
B) Reduction of the heat setting to “0“ by operating the Decrease Heat Setting Button. When this happens,
the associated Decimal Point of the cooking zone will also be turned off. If there is residual heat from this
hotplate remaining, a red ´H` will be shown in the Heat Level Display area.
The Boost Function
The Boost function is available at each cooking zone. It is used to speed up the initial heat up time (say boil
a pot of water). Select a cooking zone and set the temperature. While the decimal point on the display is lit,
press the Boost button. The display will alternate between “P” and the heat setting.
Note: The Boost function is not always available (depending on what else is being used), and if the power
requirements are exceeded, the display will flash with an alternative setting for 3 seconds. Do not leave the
appliance unattended while this function is active.
To disable the Boost function, press the Heater Selection Button for the cooking zone again (so the Decimal
Point is lit) and adjust the temperature setting with Increase Heat Setting Button or Decrease Heat Setting
Button. The display will no longer alternate between “P” and the heat setting.
Locking The Keys
The child lock is used to set the appliance up so when it is first turned on, it is in a locked mode (which must
be unlocked before a cooking function can take place). While locked, touch modifications (e.g. increase heat
settings) and others will not be possible. It is only possible to switch the appliance off.
Turn the appliance on, but do not activate any functions. Press the Increase Heat Setting Button and
Decrease Heat Setting Button together, and then the Increase Heat Setting Button again. The display shows
an “L” on all cooking zone displays (or alternating ”H” & “L”) and will remain locked even if the unit is
turned off & on.
To unlock the unit, press the Increase Heat Setting Button and Decrease Heat Setting Button together, and
then the Decrease Heat Setting Button again. The “L” displays will switch back to the heat settings and will
not be active when the unit is next turned on.
The Key Lock button can be used to stop access to any functions (except the On/Off function) while the
cooktop is being used. Once the cooktop has been set up to cook, press the Key Lock button for 2 seconds
until there is an audible alarm and the key lock symbol will be lit. Repeat the process to remove the key lock
(the key lock symbol will no longer be lit). If the unit is turned off & on, the key lock will remain active.
The Smart Pause Function
This function reduces the power of all cooking zones for 30 minutes (at which point the appliance will turn
off). Activate by pushing the Smart Pause Button. The displays will alternate between “ " “ and their correct
reading. Turn the function off by pressing the button a second time.
9
9
9