HEAT LIVE RELAX
OPERATING INSTRUCTIONS
FAN ONLY
To turn the fan on without any heat, turn the right hand control knob to the fan function and turn the thermostat
control knob fully clockwise. This function can be used to circulate air within a room.
HEATING
Turn the right hand control knob to 1 for the low heat setting and to 2 for the high heat setting. For greater
economy, use the high heat setting initially and then turn down to the low heat setting when the required
temperature is reached. Please note that the fan speed remains the same when changing heat setting; only the
heating elements are adjusted. Note: The thermostat control knob should be at a higher temperature than the
room temperature, otherwise the elements and fan will not work.
To turn the heater off, turn the knob to ‘O’.
THERMOSTAT CONTROL
The left hand control knob is for adjusting the thermostat control switch, which is used to control the room
temperature. It acts as an on/off switch for the heating elements and does not vary the heat from the elements. To
set the temperature:
1.
Turn the thermostat control knob clockwise until the maximum temperature setting is reached.
2.
Once the desired temperature has been reached, very slowly turn the thermostat control knob anti-clockwise
until there is an auditable click. The thermostat has turned off and the elements will stop producing heat.
3.
The heater elements and fan will now turn off and on automatically, maintaining the room temperature you
have set. To increase or reduce this temperature, the thermostat knob should be adjusted accordingly.
SAFETY FEATURES
1. A thermal overload protector is built in to prevent overheating.
2. When an overheat temperature is reached, the heater will automatically shut off. It can only resume operation
when the user resets the unit (see reset instructions below).
3. A tilt switch turns the heater off if it falls over (this is situated on the bottom of the heater).
To reset your heater:
1.
Unplug the heater and wait between 5-10 minutes for the unit to cool down.
2.
Then, turn on the unit again and operate normally.