DESIGNED TO PERFECTION
MODEL RBES65 & RBES96
1.
Switch the unit off and disconnect from mains power
first.
2.
Remove the filters.
3.
Unscrew the bulbs by rotating them and replace with the
same type and rating (230-240Vac E14 40W).
4.
Replace filters.
TROUBLESHOOTING
Fault Possible
Cause
Solution
Light on, but
motor does
not work
Fan switch turned off
Select a fan switch position.
Fan switch failed
Contact Everdure Service.
Motor failed
Contact Everdure Service.
Light does not
work, motor
does not work
House fuses blown
Reset/Replace fuses.
Power cord loose or disconnected
Refit cord to power outlet.
Switch power outlet on.
Oil leakage
One way valve and the air
ventilation entrance are not tightly
sealed
Take down the one way valve and
seal with sealant.
Leakage from the connection of U-
shaped section and cover
Take U-shaped section down and
seal.
Lights not
working
Broken/Faulty globes
Replace globes as per this
instruction.
Insufficient
suction
The distance between the range
hood and the gas top is too far
Refit the range hood to the correct
distance.
The Range
hood inclines
The fixing screw not tight enough
Tighten the hanging screw and
make it horizontal.
NOTE: Any electrical repairs to this appliance must conform to your local, state and federal laws.
Please contact the service centre if in any doubt before undertaking any of the above.
Always disconnect the unit from the power source when opening the unit.
7
10
Summary of Contents for RBES63
Page 11: ...DESIGNED TO PERFECTION 10 11 ...
