Everdure RBES63, Installation, Operation & Maintenance Instructions Manual

     DESIGNED TO PERFECTION 

INSTALLATION OF THE EVERDURE RBES64 & RBES92 RANGE HOODS DIRECTLY TO A WALL 

 
Ensure that the wall is structurally sound, and is capable of carrying the weight of the range hood. 

The range hood can be placed at a minimum of 600mm away from an electric cooktop, or 650mm 
minimum from a gas cooktop. The unit is held to a wall via 3 brackets (supplied with the unit): 

2)

Hook Bracket. 2)  Centre Bracket (flat). 3)  Top Bracket (U-shaped). 

Place the hood main unit (RBES92-no u-shaped section) against the wall at the correct position and mark off 

the lowest level of the unit.  Remove the unit and measure up 20mm to get the top level for the hook bracket.  
Place the hook bracket (hooks up) under the mark and mark in the 3 screw holes.  Remove the bracket and 
drill three (3) Ø8mm holes 115mm apart.  Insert plastic plugs into the holes and fix the hook bracket onto 
the wall (see figure 1) with three (3) 40mm screws.  Place the hood main unit onto the hooks. 

If the position is correct, mark out the positions for the safety screw holes (through the back of the unit), and 
remove the hood body.  Drill two (2) Ø8mm holes and fit in two (2) plastic plugs. 
Screw the one way valve in position at the top of the body (4 x 8mm bolts) & fit the soot tube to the one way 
valve (see figure 2).  Hook the main unit back onto the wall (see figure 3).  Screw the 30mm screws into the 
wall through the back of the unit.  RBES92-Slide the glass into position and fix into place with 4 bolts, nuts & 

washers (See fig 4).   
Fit the u-shaped sections together & screw the centre bracket onto the back of the outer u-shaped section 
using the supplied 8mm screws (this helps keep the width at the back even with the front) (see figure 5).  
Place the u-shaped sections onto the main unit and mark the hole positions to fix the centre bracket to the 

wall.  Remove the u-shaped sections, drill two (2) Ø8mm holes and fit in two (2) plastic plugs.  Place the u-
shaped sections back onto the main unit, fix to the wall with two (2) 40mm screws and run the loose end of 
the soot tube outside. 
Calculate the final height of the u-shaped section and pull out the inside u-shaped section to a suitable 

height (see figure 6) to check.  Mark the 2 sides near the top and push the inner section out of the way.  
Place the top bracket (slots to the bottom) centred between the 2 marks, mark the 2 screw holes. Remove the 
bracket and drill two (2) Ø8mm holes at the marks.  Insert plastic plugs into the holes and fix the hook 
bracket onto the wall (slightly loose) with two (2) 40mm screws.   
Pull up the inside u-section to allocate the top bracket correctly, and tighten the screws holding the bracket.  

Pull the u-section over the bracket completely and fix into place with 2 screws at the sides (see figure 6). 
Note: The top edge of the u-shaped bracket matches the top edge of the u-shaped section – adjust according 
to your own needs. 
 
For timber framed houses, special care should be taken that all brackets are attached to areas that will 

support the weight of the range hood. 
 
 
 

 
 
            Figure 1                                   Figure 2                                              Figure 3 
 
 

 
 
  
          Figure 4                                    Figure 5                                             Figure 6 

5 

6