Document No. 1112M001 Revision 1.8 Date: June 2013
23
4.8 Nacelle and Nosecone
Check all previous work before fitting the “covers”.
You need the fastener pack marked “Nacelle and Nosecone”
for this work
►
Slide the nacelle (36) over the generator and secure at the rear
with two M6 nut sets (34). Torque to
4Nm (3ft lb)
.
►
Secure the nacelle at the front with four M5 screws and
washers (35), Torque to
3Nm (3ft lb)
.
►
Fit the nosecone (31) over the stiffener ring. Fit the nosecone over
the three support posts.
►
Secure the nosecone to the stiffener ring with six off M6 Nylock
nut sets (32) and torque to
4Nm (3ft lb)
.
►
Fit the nosecone to the three support posts with three stainless M8
PARTS LIST
ITEM
QTY
DESCRIPTION
31
1
Nose Cone
32
6
M6 Nylock nuts and washers
33
3
M8 Nylock Nuts and washers
34
2
M6 Nylock Nuts and washers
35
4
M5 CH screws and washers
36
1
Nacelle
