IR REMOTE CONTROLLER
POWER
Under normal working mode, short press
POWER key, to enter standby mode;
Press it again, the camera will do
self-configuration, then go back to HOME
position.
It will go to preset position if power on model
has been set before.
FREEZE
（
Not Supported in USB
）
Short press FREEZE key to freeze/ unfreeze the
image.
IRT (IR Transfer/IR Pass)
Open / close the IR pass function. Once press
the IRT key, the camera will receive and
Pass the IR remote control signal to the
codec/terminal (via VISCA IN port).
SET 1~SET4 ADDRESS SETTING
Long press for 3 seconds until the key light ON,
to set camera address.
CAM1~CAM4
（
CAMERA SELECTING
）
Short press to select the relative camera.
PRESET NUMBER KEY (1-9)
Set preset: long press (3 seconds) the number
key to set preset.
Run preset: Short press the number key to run
preset.
CLR PRE (CLEAR PRESET)
CLR PRE+ number key:
to clear the relative preset.
Long press to clear all presets.
9
WWW.EVERETIMAGING.COM
