D.
Cautions
1.
For safety, always switch off your appliances before connecting.
2.
For indoor use only.
3.
Whenever you change a wifi network, reconnection is required.
4.
Do not plug in and out the device continually. Always wait for an interval of 10 seconds
AVERTISSEMENTS
1 Pour plus de sécurité, veuillez toujours éteindre vos appareils avant la connexion.
2 Pour une utilisation en intérieur uniquement.
3 Dès que vous modifiez un réseau wifi, la reconnexion est nécessaire.
4 Ne branchez et connectez pas l’appareil fréquemment . Toujours attendre un intervalle de 10
secondes.
E.
Specifications
1.
Power Rating : 125V~, 60Hz,
2.
Resistive Load : 1800Wmax.
3.
Frequency
: 2.4GHz (meets the requirements of IEEE802.11/b/g/n standard)
F.
Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
Limited by local law regulations, version for North America does not have region selection option.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
