EFN Series Fisheye IP Camera
83
Upload to FTP: Check the box if you want the camera to upload the recordings to the FTP server
entered in the FTP Repository Settings (see
7.3.3 Notification
).
Record to SD Card: Check the box if you want the camera to start recording its video feed (when
the event occurs) on an on-camera SD Card (if such a card has been inserted).
Note: The recording will only be as long as the combined Pre- and Post-trigger Buffers, so
make sure you enable at least one of these buffers, especially the Post-trigger Buffer.
Network Alarm: Check the box if you want the camera to send a network alarm signal (when the
event occurs) to the CMS servers. Note that you have to configure the Network Alarm Settings
for this function to work (see
7.3.3 Notification
).
: Set up the Event information and click the Create button, the created Event information
will be listed in the Event List.
: Highlight an item in the Event List and then click the Remove button to remove the
highlighted item.
: Highlight an item in the Event List and edit the Event information on the left-side. Click the
Edit button and the item will be edited.
: Click the button to cancel the changes and return to the previous settings.
【
Event Trigger Settings
】
Input 1 Trigger Type: This function is only available if the camera features the alarm I/O cable.
Select Normal Open or Normal Close from the drop-down list.
Output 1 Contact Type: This function is only available if the camera features the alarm I/O cable.
Select Normal Open or Normal Close from the drop-down list.
Tamper Duration Time: Set up a duration time between 10 and 120 seconds. When a tampering
event has been detected and the duration reached the setup time, the camera will trigger the
event.
【
Trigger Options Settings
】
Pre-trigger Buffer: Select the duration for the buffer. This will determine the amount of footage
(length of time) before the event trigger moment that will be included in an event-triggered
video recording, if that buffer and video recording has been enabled in the Event Management
field.
Post-trigger Buffer: Select the duration for the buffer. This will determine the amount of footage
(length of time) after the event trigger moment that will be included in an event-triggered video
recording, if that buffer and video recording has been enabled in the Event Management field.
Click Apply to apply the changes or Cancel to cancel the changes and return to the previous settings.
