100
Note: Make sure the modem is in bridge mode. If your Internet Service Provider is
BellSouth you may have a modem/router. BellSouth provides a Westell modem
that includes a built-in router. You will need to disable the router functionality.
The next step is to open ports within your router. Open virtual ports in the router (Log
into the router using a PC)
o
EDR Ports to open: 80, 1600,1601,1602,1603, 37260, 37261, 37262, 37263
Note: If your Internet service provider blocks port 80 you must use a different
port to access the DVR through the DVR’s Network Menu Setup.
Note: If you wish to have multiple users log into the DVR please open a range for
the control and data ports on your router. For example if you would only like 4
clients to connect to the DVR open 1600-1603 and 37260 ~ 37263
If you have a Dynamic IP address and have open the ports simply go to Chapter 13 to
Configure DDNS.
Once you have reached this point and you have restarted the digital recorder.
To access the DVR from a computer simply open Internet Explorer and in the address bar
type:
http:// and the IP address of your internet service provider.
Note: If your Internet service provider blocks port 80 you may use a different
port to access the DVR through the DVR’s Network Menu Setup.
Summary of Contents for 920
