44
4.3.4
Video Loss
Figure 4-6 Camera Menu – Video Loss
Camera:
Select the camera you wish to configure, “Title” will change to the title name of the selected
camera.
Enable:
Check box to enable Video Loss
detection.
Log:
Check box to record video loss events in the log.
Pre-alarm Record:
Check box to start copying recorded video to the hard disk from 5 seconds before the
video loss. (Pre-alarm recording rate will follow the “
Normal
” frame rate setting)
Buzzer:
Check box to enable the buzzer when a video loss event occurs.
Email Notify:
Check box to enable email notification when a video loss event occurs. Email operation
requires that valid email settings have been entered in the Network Setting/Email setup screen. (See
Section 4.6.2 Email for more information.)
Network Alarm:
Check this box to send out a network alarm to a client PC when video loss occurs. (This
feature requires PowerCon software on the client PC and proper settings for the Alarm Server in the
Network Setup menu; see Section 4.6.4 Alarm Server for more information.)
Alarm Output:
This will transmit a signal through the alarm output relay. It can be set to either “
NONE
” (not
active) or “
1
” (indicating which alarm relay is active).
Output Type:
Output action when alarm is triggered.
Timeout: Alarm output lasts for a set time duration. If this option is selected, a field will appear for
setting the duration. Time duration selectable from 1 to 150 seconds.
Permanent: Alarm will remain active until the user presses “
Enter
” key on front panel.
Transparent: Alarm output continues as long as there is a video loss.
Trans+Timeout: Alarm output continues until the event ends, then continues for a set time duration.
