EDN228
38
Click
Apply
to apply the changes or
Cancel
to cancel the changes and return to the previous settings.
Note:
Uploading a new language file will cause the system to reboot automatically. Please create
a new network connection to the IP camera when the reboot is complete.
【
Maintenance
】
Reboot:
Click to reboot the unit without changing any of the settings. Use this function if the
unit is not behaving as expected.
Restore:
Click to restart and reset most of the current settings to their factory default values.
The only settings that will not be changed to default are: IP Settings and DDNS Settings.
Initialize:
This function can only be set up in the
Advanced
tab. This button should be used
with caution. Clicking this button will return all of the camera's settings, including the IP
address, to the factory default values. The camera will then have to be reconfigured.
【
Save Configuration Server
】
Save:
To make a backup file of the machine’s current configurations, click this button to save all the
configurations to a configuration file. This will enable the user to reload these configuration settings
if the settings are changed and there is unexpected behavior.
【
Load Configuration Server
】
Select
Video
to apply only the video parameters from the configuration file to the system. Select
Network
to apply only the network parameters from the configuration file to the system. Select
All
to
apply all the parameters from the configuration file to the system.
Browse:
Click the
Browse
button to locate the saved config. File.
Upload:
Click the
Upload
button to restore the system based on the selected parameters (Video,
Network or All).
【
Video Format
】
Select NTSC or PAL for your local scanning system. Click
Apply
to save the setting.
【
Upgrade Firmware
】
This function can only be set up in the
Advanced
tab. Click the
Browse
button
to find a previously prepared firmware upgrade file. Click the
Upload
button to install the new
firmware.
