4
Base Plate
Camera Body
Fix Screw
3.
Connect the
Power Cable
to a 12VDCpower source. Connect the
Video
Output Cable
to a monitor or DVR.
4.
You can use the
Joystick
on the cable to configure camera OSD settings.
Remove the Protection Cap from the Joystick before using it.
UP
DN
Configuring OSD Settings:
•
Push the Joystick up / down to select among
menu items.
•
Push the Joystick left / right to adjust the level of
the selected item.
•
Press the Joystick to enter the submenu or exit
the OSD Setup Menu.
5.
You can optionally adjust the camera angles. To do so, unscrew the 4 cover
screws using the supplied
L-Type Wrench
and then remove the cover. Adjust
the camera angles (Tilt: 60°, Pan: 350°, Rotate: 350°). After adjusting camera
angles, screw back the camera cover.
350
°
350
°
60
°
