6
3.
Loosen the screws which lock the tilt mechanism. Rotate the pan and tilt mechanisms to point
the camera in the desired direction. Rotate the camera module on its axis if necessary to align the
image ‘upright’. Loosen the lens adjusting screws and adjust the lens to obtain the desired field of
view and focus.
4.
Lock the lens and tilt screws. Put the dome cover back and align the clear window in the dome
cover with the lens. Attach the dome cover to dome base with the 4 mounting screws.
NOTE:
The cover only goes on in ONE direction. There is a key and slot; if not aligned, cover will not
close properly.
NOTE:
If you move the camera module
, it is necessary to loosen the dome and liner and
reposition
the liner so the lens points out through the slot
, and the rubber seal presses onto the clear part of the
dome and not the liner. Loosen 4 Philips screws, reposition liner, then TIGHTEN four cover attachement
screws (else seal and vandal resistance is compromised).
Lens adjustment
Focus adjustment
Tilt lock
2 places
