2
1.4 Dimensions
75.5mm / 3"
68.8mm / 2.7"
78
.6
mm
/
3.1
"
3. Installation
Screw Hole
Screw Hole
Optionally thread the
cable through this hole
Loosen to adjust Sunshield / Camera Angle
4
5
4
Loosen to adjust Sunshield / Camera Angle
Loosen to adjust Bracket Angle
1
1
2
3
Power Cable
Video Output Cable
1.
Attach the Camera Bracket to the surface where you want to mount the camera and mark the
Screw Hole locations on the surface. Drill two screw holes on the surface and insert the
supplied two Anchors to the holes. Screw the Camera Bracket to the surface using the supplied
two Screws.
2.
Optionally drill another hole in the middle between the two screw holes only if you want to
thread the cables through the surface.
3.
Connect the camera to a 12VDC power source using the supplied
DC Power Pigtail Cable
or
power adapter. Connect the video output cable to the monitor.
4.
To adjust the Sunshield or Camera angle, loosen the two screws on both sides and then adjust
the angle.
5.
To adjust the Bracket angle, loosen the screw on both sides and then adjust the angle.
