g. When all the adjustments and settings are completed, overlaying the
cover gently. Be careful not to damage to the “O”-Ring and camera
components.
h. To reassemble the sun shield, match the hole on the sun shield to
the back fixing plate of camera, Fix the screw on the front fixing plate.
Make sure the wider side of the fixing plate holds the edge of the
camera well.
5. Attach the camera onto the mounting bracket.
6. Loosen the swivel screw and point the camera to the desired direction.
7. Tighten the swivel screw. To strengthen the fixing power of the swivel
screw, tighten the set-screw with the set-screw wrench. (supplied)
Notes:
(A) Make wiring connections only after it has been determined that
power has been disconnected.
(A) There is a desiccant pack attached to the housing base under the
camera which is designed to absorb any moisture trapped inside the
housing during adjustment. To avoid excessive moisture build up,
it is recommended that the camera not be installed in rainy or
excessively damp conditions. It is also advisable to limit the
number of times the housing cover is removed. The desiccant pack
can be replaced if condensation develops inside the housing.
6
