28
3.3.2 LENS
When the SETUP menu is displayed on the screen, please direct the arrow to point to “LENS” by
using the UP and DOWN buttons.
The iris opening can be adjusted in DC mode in LENS LEVEL. The level can be adjusted from 0
to 50.
Please select RETURN and press the SETUP button if you would like to return to the previous
menu.
3.3.3 EXPOSURE
3.3.3.1 SHUTTER
1. When the SETUP menu is displayed on the screen, please direct the arrow to point to
“EXPOSURE” -> “SHUTTER” by using the UP and DOWN buttons.
2. Select the shutter mode by pressing the LEFT or RIGHT button.
Select from x256, x128, x64, x32, x16, x8, x4, x2,
1/60 (1/50 at PAL)
, FLK, 1/250, 1/500,
1/1000, 1/2000, 1/5000, 1/10000, 1/100000 for NTSC model or x256, x128, x64, x32, x16,
x8, x4, x2, 1/50, FLK, 1/250, 1/500, 1/1000, 1/2000, 1/5000, 1/10000, 1/00,000 for PAL
model.
FLK: Please select “FLK” mode when flickering occurs on the screen, because of an
irregular balance between illumination and frequency. NTSC model: 1/100, PAL model:
1/120.
3. Select RETURN and press the SETUP button when you finish all the settings.
3.3.3.2 AGC (AUTO GAIN CONTROL – BASIC LOW LIGHT SIGNAL AMPLIFICATION)
Please direct the arrow to point to “AGC” by using the UP and DOWN buttons.
Select the level you would like to choose by pressing the LEFT or RIGHT button. The more the
level of gain increases, the brighter the screen, but the level of noise increases as well. Please
select from HIGH,
MIDDLE
, LOW and OFF.
Note: AGC must be on for sense-up low light boost to function.
3.3.3.3 SENS-UP
SENS-UP is used to keep a brilliant, vivid screen image under low light level conditions by
automatically compensating for changes in the level of light.
Please direct the arrow to point to “SENSE-UP” by using the UP and DOWN buttons.
Select the mode you would like to operate by pressing the LEFT or RIGHT button.
AUTO:
Low light level auto mode. Press SET for adjusting the maximum number of interpolated
images. (Default is Auto, 8X)
OFF:
The function is disabled.
Press select RETURN and the SETUP button when you finish all the settings.
NOTE:
Make sure for default setting 1/60 (NTSC) / 1/50 (PAL), if SENS-UP function is needed in the
installation. All other Shutter modes will disable SENS-UP functionality.
