EZ655p
14
4.2.8
DAY/NIGHT
You can select
Color
or
Auto
(with submenu) mode to configure the
picture to be displayed either in color or black and white.
SETUP MENU 2/3
HLC/BLC
DAY/NIGHT
EZOOM
DIS
PRIVACY
MOTION DET
BACK
↵
EXIT
↵
↵
AUTO
↵
↵
OFF
↵
OFF
NEXT
↵
SAVE ALL
DAY/NIGHT SETUP
BURST
DELAY CNT
DAY
→
NIGHT
NIGHT
→
DAY
IR OPT
IR LED
EXTON
RETURN
↵
OFF
003
000
000
OFF
OFF
ON
↵
【
Burst
】
: When the camera switches to the B/W mode in low light
condition, you can set the function off for monochrome images or set it
on to remain color images. Please note that if the camera cannot switch
back to COLOR mode from B&W mode, please turn the BURST function
on.
【
Delay CNT
】
: Adjust the delay time level (0-255) for day/night switch.
【
Day→Night
】
: Adjust the Day→Night switch threshold level (0-255).
【
Night→Day
】
: Adjust the Night→Day switch threshold level (0-255).
【
IR OPT
】
: Select
On
to set up the Smart IR function.
IR OPTIMIZER
SMART IR
LEVEL
ATR WD-EX
RETURN
↵
CENTER
↵
015
ON
【
Exton
】
: When outside signal is worked, DAY & Night is interlocked.
EXTON
DELAY CNT
POLARITY
RETURN
↵
003
ACTIVE LOW
[Smart IR]: Enter to adjust the area and
position of the smart IR.
[Level]: Adjust the level of smart IR. (0-31)
[ATR WD-EX]: ATR WD-EX function only works
in B/W mode.
When it is set to OFF, this
function is activated. If it is set to OFF, the
Digital WDR function works at night.
[DELAY CNT]: Adjust the delay time (0~255
sec.) for day / night switch. If it is set to 3
sec., it will take 3 sec. to switch between the
day/night modes.
[Polarity]: Select Active High, the IR LED turns
on and the camera switched to the B/W
mode. Select Active Low, the IR LED turns off
and the camera switches to color mode.
